Miếng Dán Phản Quang Chống Thấm Nước Kích Thước 30x11cm

Giới thiệu Miếng Dán Phản Quang Chống Thấm Nước Kích Thước 30x11cm

Size: About30*11CM
"Precautions"
1Before the product is pasted, the topcoat should be wiped clean. After the surface is thoroughly dried, the double-sided adhesive tape can be used;
2After pasting24It is forbidden to wash the vehicle within 24 hours to prevent the product from falling off again.


Material: Wood Quality: engineering grade reflective film (non advertising grade) is used for reflective class,Super waterproof and sunscreen, no mark after degumming. It is characterized by wide incident angle of light, strong reflected light, and safety at night,3—5Years never fade,No pulverization. High refractive index, good reflection effect

[paste method]
Dry sticking method-Suitable for bumper stickers or small stickers
Tools: clean rags, scraps, credit cards
[general pasting method]
1Cleaning: clean the car body and keep it dry;
2Positioning: fix the position of the paste, tear out a small side of the transfer film (the transparent film pasted on the reflective paste) and fix it on the car. After confirming that there is no error, slowly peel off the backing paper, paste and scrape it flat (you can scrape the telephone recharge card, etc.);
3Press flat: after sticking, scrape and press repeatedly. Remove the transfer membrane.
[quick paste method]
If the sticker is not big, you can tear off the transfer film and the sticker and stick it again. But care must be taken to avoid accidental adhesion.

[large vehicle sticker method](Two person operation is recommended)
Tools: spray bottle, clean cloth, scraper, art knife, air duct
　1After cleaning the car body, spray water on the part of the car body to be pasted with a watering can, which is mainly used to reduce the viscosity of the sticker and facilitate the adjustment of the position.
2After determining the position to be pasted, transfer the transfer film (transparent adhesive film pasted on the reflective sticker) together with the car sticker from right to left[Or from top to bottom]Take up one side and press it on the car watch with a rag, then stick it on one side, flatten it with a rag on the other side and peel off the backing paper on the other side.
　3, door handle or The anti-collision strip should be cut and wrapped or loaded according to the situation.
　4After the general position of the figure is confirmed, the scraper is used to scrape off the water and bubbles repeatedly, and the scraper is used to scrape obliquely from right to left; Then the transparent transfer membrane was removed.
　5In case of car door and seam, use art knife to split and stick inward.
　6Try to let the moisture in the car stickers dry thoroughly. If possible, use an air duct to moderately heat and dry them. Suggestions:24Try not to be exposed to the sun within hours,48Don't wash the car within hours.

Hình ảnh sản phẩm

Giá WTFUEL